CRP Dynamometers

It is therefore possible to control the speed of the forward and the rear dynamometer independently from each other. All 3 CRP dynamometer types have separate driveshafts for the forward and rear dynamometer to facilitate the connection of two motors. Alternatively, the two driveshafts can be connected through a gearbox normally with a transmission ratio of1:1 so that it is possible to drive both the forward and the rear dynamometerat the same speed in opposite directions, from one motor.

Sensitivity at rated torque and thrust, output voltage/supply voltage, approximately: 1.5 mV/V
Maximum speed (provided that suitable drive equipment is available): 1800 rpm
Current supply for the measuring system (constant voltage): d.c. or a.c.
Rated torque: ± 7Nm
Rated thrust: ±250 N
Torque measurement:
Recommended supply voltage: up to 8V
Max. supply voltage: 20V
Thrust measurement:
Input bridge resistance, approximately: 133©
Output bridge resistance, approximately: 120©
Input bridge resistance, approximately: 274©
Output bridge resistance, approximately: 240©
Recommended supply voltage: up to 6V
Max. supply voltage: 10V
Maximum speed (provided that suitable drive equipmentis available): 1800 rpm
Current supply for the measuring system (constant voltage): d.c. or a.c.
Sensitivity at rated torque and thrust, output voltage/supply voltage, approximately: 1.5 mV/V
Net weight without calibration device,approximately: 17 kg
Rated torque: ±3 Nm
Rated thrust: ±30 N
Torque measurement:
Recommended supply voltage: up to 8V
Maximum speed (provided that suitable drive equipment is available): 1800 rpm
Current supply for the measuring system (constant voltage): d.c. or a.c.
Sensitivity at rated torque and thrust, output voltage/supply voltage, approximately: 2 mV/V
Max. supply voltage: 20V
Input bridge resistance, approximately: 133©
Output bridge resistance, approximately: 120©
Input bridge resistance, approximately : 274©
Output bridge resistance, approximately: 240©
Recommended supply voltage: up to 6V
Max. supply voltage: 10V
Rated torque: ±24Nm
Rated thrust: ±700 N
Net weight without calibration device: 17 kg.